ralf
Junior Member
Posts: 93 
|
Post by ralf on Dec 1, 2017 19:53:04 GMT
|
|
|
|
Post by 3dprintingmeathead on Dec 1, 2017 21:19:46 GMT
Not bad, I do believe that would be called x axis motor mount though. The z does not have a carriage. This design looks great. It does take away my favorite x belt tightening method when there is no tensioner though. I like to remove all but 1 bolt from the motor, move the belt in the x carriage a few notches, and use the 1 bolt as a fulcrum and pull the motor to tighten the belt. Tough to explain here, will do a video on it later, but with a fully captured motor, this m re this would not work, so a tensioner is a must.
|
|
ralf
Junior Member
Posts: 93
|
Post by ralf on Dec 2, 2017 15:50:09 GMT
That’s a interesting approach, like a generator in an old car ?  |
|
|
|
