jana
New Member
Posts: 3
|
Post by jana on Mar 15, 2019 13:42:31 GMT
Hello
When I want to autohome my 3dprinter or start a project the extruder keeps going to the left of the x-axis, hitting the end of it. How can I solve this problem?
Thank you in advance! Jana
|
|
|
Post by kioskfan on Mar 15, 2019 20:55:54 GMT
I bet your limit switch has failed or the plug on the cpu has wiggled out a bit. You can manually check the switch with a meter if you have one, you can also check the switch with software like pronterface. My x switch failed shortly after I got it, I think there was a spare switch in the parts kit but if not they are pretty inexpensive on ebay. Hope this helps.
|
|