|
|
Post by cipispe on Dec 4, 2018 12:29:31 GMT
Hello people.
I wonder if is possible to add auto resume function to DP4/DP5 ? Maybe to change the mainboard..
|
|
|
|
Post by kioskfan on Dec 4, 2018 17:11:25 GMT
A new mainboard will potentially give you a whole host of new features and it's likely the biggest upgrade you can do to your 3D printer. A couple members here have done this, maybe they will chime in? I've put an old APC UPS on mine after a short power failure caused a failed print. It only cost me $20 to replace the dead batteries in my free unit and it's a whole lot easier plugging in than changing the motherboard. Of course a new motherboard sounds nice too...
|
|
