|
Post by bortolostefano on Nov 21, 2018 13:35:26 GMT
Hi friends, i can change the green bed leveling sensor of my DMS DP5 using another sensor that can see and use glass plate ? thanks 
|
|
denis
New Member
Posts: 18
|
Post by denis on Nov 21, 2018 16:18:23 GMT
you can fix it on the portal, only to make the bottom metal that the sensor would work, and can be replaced by another on aliexpress many varieties and different working height ,and different structures
|
|
|
Post by kioskfan on Nov 21, 2018 16:29:25 GMT
If you look on your SD card you'll find a file called, Zxianwei.gcode. This file allows you to replace the proximity sensor with a limit switch.
|
|
|
Post by kioskfan on Jun 3, 2019 3:29:38 GMT
Did this solve your problem? Does anyone else know about changing the sensor and what ones work?
|
|
|
Post by bortolostefano on Oct 3, 2019 6:24:13 GMT
Did this solve your problem? Does anyone else know about changing the sensor and what ones work? hi Kiosfan i have buyed this sensor LJ12A3-4-Z/BX. Today this sensor arrive to my home. 
i want ask for mount it if i must change code or only connect the 3 cables (+ - and signal). thanks
|
|
|
Post by kioskfan on Oct 6, 2019 19:10:50 GMT
I don't know but I've been trying to find out, I guess you're at the point where you can find out. Please let us know how it works. Best of luck.
|
|
|
Post by bortolostefano on Oct 7, 2019 6:02:26 GMT
Hi Kiosfan yesterday i have found a solution for the original green sensor SN04. I have put a small piece of aluminum paper in the home position. The sensor read di Z position and now i can use it normally.
One question:
it's posible change home position (0,0,0) and put it in one corner of plate ? i have firmware 1.1.4 and home position is in the center of plate.
thanks
|
|
|
Post by kioskfan on Oct 7, 2019 15:08:26 GMT
I did a similar thing for a while when I thought my sensor was going bad, I but box cutter blades on the bed under the sensor and adjusted the sensor a bit higher and it worked but eventually I just tried to readjust the sensor on the bed and that worked too so everything was okay. It takes a lot of finicky work to keep any 3d printer running.
|
|
|
Post by bortolostefano on Oct 8, 2019 14:54:54 GMT
i think that for modify home position it's necessary modify firmware...right ? i want change the place of home. Not in the center but on one corner of plate.
|
|