|
|
Post by pa1838 on Aug 12, 2018 21:03:57 GMT
Hi there,
Can anybody help me here. I bought a heavy modified Dp5 6 month ago and want to upgrade the FW.
I am a newbee and is in doubt haw to do it. My imfo screen is saying that I have
an Salento 3D Pronta. Which file do I use.
Pls. adv.
Best regards,
Per
|
|
|
|
Post by kioskfan on Aug 13, 2018 4:26:45 GMT
From that startup screen I'd say you have the factory firmware, the same as what I use. What has been done to your machine?
|
|
|
|
Post by pa1838 on Aug 13, 2018 14:27:43 GMT
FW is 1.0 and I would like to install 1.1.9 (the latest)
All is steel or aluminium, now.
New 4mm Aluminium Y sledge,
New bearings in the Y sledge, made in one piece, so they cant move
Mosfed installed on the Hedbed, in order not to take current from the mainbd.
Timer that shut down the printer 10min after finish printing.
Fan`s replaced by 12V which is easier to bye (in DK), each controlled separately.
New Z end stop, which works better than the original.
|
|
|
|
Post by kioskfan on Aug 13, 2018 15:51:49 GMT
Sounds like you have a nice machine, you should start a new thread and show us all the work that has been done as you are now near the lead in modified DP5s.
|
|
|
|
Post by pa1838 on Aug 14, 2018 15:25:16 GMT
I bought it used like this but, I can try.
One of the coolestt things is that if you print from the memory card, you turn of the power
and the printer continues to print until done and after 10 min, it turns of the remaining Power.
This is very need when printing over night unattended.
|
|
|
|
Post by kioskfan on Aug 14, 2018 16:07:52 GMT
It has a UPS built in? Who did all this work and didn't tell us about it?  |
|
