allan
Meathead's blog
Hi Guys any news or updates!
Posts: 6
|
Post by allan on May 26, 2018 6:57:16 GMT
Hi Guys its been a while i was not able sign in our forum. I have an issue regarding the printing.. yesterday i print small object about 60x40x75mm ht. from the start of the printing its fine until 95% printed. its going crazy did not continue..but i saw it it sudden raise up the z axis and doing continue printing. i dont know what to do..its always happen sometimes. but this is not normal. please anyone have experience this incident? or anyone have solve this issue? please i need someone can advise what to do.. awaits your reply
|
|
|
Post by kioskfan on May 27, 2018 5:35:38 GMT
I'm not sure I understand what you are describing. The Z axis raises up near the end of the print? Did you try again? Did you look at the G code?
|
|