|
Post by kioskfan on Aug 20, 2017 22:09:30 GMT
Hi Group!,
This is not specifically a problem but since you've been so good with every other issue I've had I thought Id run this by the group.
My seven year old Windows 7 laptop is on it's last legs and I'm replacing it with a Mac. I have other Macs so I'm good for all my software except for Cura which I've only used on the laptop. Is there a specific version of Cura for Mac that works best with the DP5 or is there an alternative to Cura that works better?
Thanks!
|
|
|
Post by 3dprintingmeathead on Aug 20, 2017 22:11:18 GMT
Stick with cura, newest version. You might not get the print via USB, but the features are the best money doesn't have to buy.
|
|
|
Post by tanephar on Aug 21, 2017 2:26:12 GMT
My personal choice after trying quite a few slicers is MatterControl, which has MAC functionality too.
|
|
|
Post by kioskfan on Sept 3, 2017 4:54:39 GMT
My personal choice after trying quite a few slicers is MatterControl, which has MAC functionality too. I have MatterControl running, you wouldn't happen to have a Setup you could share with me?
|
|
|
Post by tanephar on Sept 4, 2017 0:38:31 GMT
Sure can, in fact I have screenshots of all the tabs and you can find them right here, mega.nz/#F!AhQGXQCL!pdhlOpDDESF1BVn1k9x6Cg You might just need to tweak things a little for your filament but everything else should be shiny.
|
|