|
Post by liamwilde on Nov 11, 2017 12:44:19 GMT
So I built my DP5 yesterday, started my first print I don't know what went wrong but here is the result. Attachments:
|
|
|
Post by Abrew on Nov 11, 2017 13:37:36 GMT
It looks to me like either it didn't finish printing or you have the top layers set to zero. Is the nozzle clogged?
|
|
|
Post by liamwilde on Nov 11, 2017 13:55:04 GMT
Hi I stoped the print because the infill and circles don't look right
|
|
|
Post by 3dprintingmeathead on Nov 11, 2017 14:21:09 GMT
Looks like underextrusion to me, I dealt with that a lot. Recommend cold pulls. If you heat up your hot end and raise the z, manually extrude 20mmm, if it curls up right out of the nozzle, you got a clog.
|
|
|
Post by liamwilde on Nov 11, 2017 14:31:20 GMT
ok thanks i'll try changing the nozzle and printing again
|
|
|
Post by tanephar on Nov 11, 2017 21:09:30 GMT
If you haven't calibrated your extruder yet this too could cause the under extrusion. If you change nozzle and still have the problem that would be the next logical step.
|
|