looka
New Member
Posts: 4
|
Post by looka on Jun 13, 2018 13:08:00 GMT
does anyone print TPU, ninjaflex or similar filament with DP5?
|
|
|
Post by kioskfan on Jun 13, 2018 16:56:24 GMT
I think 3dprintingmeathead has done a bunch of work on flex filaments. He went so far as to modify his printer if I remember correctly, let's see if he pops in.
|
|
|
Post by 3dprintingmeathead on Jun 13, 2018 20:15:00 GMT
Most bowdens cannot print flex filament because the hot end is too far away from the extruder. I say most because some of the 2.85mm bowdens like the ultimaker fo it pretty well. Direct drive has less trouble with pushing the wet noodle down the tube, and other new designs like the new titan v6 shorten the distance from the extruder to the hot end to print easier. I have printed nylon with the dot but never tried to print flex before or after my conversion to direct drive.
|
|
looka
New Member
Posts: 4
|
Post by looka on Jun 23, 2018 8:39:30 GMT
ok. thank you!!!
|
|
|
Post by herois on Aug 8, 2018 13:03:44 GMT
I printed the secret TPU, the speed of printing is slower the better is the lot of video on youtube on the subject of printing, I had attached guides filamentu and only so much
|
|