|
Post by jasonsu26 on May 2, 2018 13:07:13 GMT
Recently i just brought this printer from a seller. What he did was : calibrated the printer and etc. So what did happened was as following: I tried to print something from cura. The setting was fine , was heating the filament before printing starts. So what happened is that , throughout the printing was fine. Until to a point it return back to a state where it is like autohome. And the printing stopped halfway.
So anyone can help me out with this ? And what step did i just missed out from printing .stl files ?
|
|
|
Post by kioskfan on May 2, 2018 15:37:52 GMT
Hi jasonsu26, welcome to the board.
Let me understand what is happening. Everything seemed to be working fine, until the machine stopped without finishing the print? Did you get any clues on the display? Sounds like a loose cable or your power. Can you provide any more details, photos?
|
|
|
Post by jasonsu26 on May 2, 2018 15:59:07 GMT
Yep the printing was normal till halfway. And it was left to print by itself for one hour and so. After that , it stopped by itself. And the printing was halfway and uncompleted. Would that be something with the printer or the setting i should do ? I was using cura for printing the .stl files.
|
|
|
Post by kioskfan on May 2, 2018 18:23:30 GMT
Did you try again? Might have been a one time thing. Do something small and watch it.
|
|